--- a/host/utilities/bladeRF-cli/src/cmd/cmd.c
+++ b/host/utilities/bladeRF-cli/src/cmd/cmd.c
@@ -135,7 +135,7 @@
             "\n"
             "\tGenerate and write an I/Q correction paremeter table to the\n"
             "\tcurrent working directory, in a file named <serial>_dc_<rx|tx>.tbl.\n"
-            "\t'f_min' and 'f_max' are min and max frequencies\n" "\tto include\n"
+            "\t 'f_min' and 'f_max' are min and max frequencies\n" "\tto include\n"
             "\tin the table. 'f_inc' is the frequency increment.\n"
             "\tBy default, tables are generated over the entire frequency range,\n"
             "\tin 2 MHz steps.\n"
@@ -538,7 +538,7 @@
             "\n"
             "Notes:\n"
             "\tThe n, samples, buffers, and xfers parameters support the suffixes\n"
-            "\t'K', 'M', and 'G', which are multiples of 1024.\n"
+            "\t 'K', 'M', and 'G', which are multiples of 1024.\n"
             "\n"
             "\tAn 'rx stop' followed by an 'rx start' will result in the samples file\n"
             "\tbeing truncated. If this is not desired, be sure to run 'rx config' to\n"
@@ -620,7 +620,7 @@
             "\n"
             "Notes:\n"
             "\tThe n, samples, buffers, and xfers parameters support the suffixes\n"
-            "\t'K', 'M', and 'G', which are multiples of 1024.\n"
+            "\t 'K', 'M', and 'G', which are multiples of 1024.\n"
             "\n"
             "\tFor higher sample rates, it is advised that the input file be\n"
             "\tstored in RAM (e.g. /tmp, /dev/shm) or to an SSD, rather than a HDD.\n"
